Complete Dryer Vent Repair & Installation in Johns Creek, GA

The most common cause is a clogged duct line restricting airflow: the dryer works but the hot, moist air can't exit fast enough. Other causes are a kinked or torn flex pipe, an undersized booster fan on a long run, or a stuck exterior vent flap. A standard cleaning fixes about 80% of these calls.

Yes. A new dryer plus an old uncleaned vent equals a guaranteed lint backup within a year and a shorter dryer lifespan. We can clean the vent the same day as your new dryer install. Customers who skip this almost always call back within 6 to 12 months with a clog.

Yes. We disconnect the dryer, brush and vacuum the full duct line from the dryer end through the exterior termination, clean the exterior vent hood and louvered cap, and confirm strong airflow at the outside end. Working from one end only is a pattern we see when customers call us after a bad job.

Yes — flex pipe replacement is one of our most common add-ons. Old vinyl or plastic flex tears easily and is no longer code in most jurisdictions; if your setup is at risk we'll tell you on the walkthrough and quote a semi-rigid metal replacement before starting.

Yes. Inline booster fans help townhouses, second-floor laundry rooms, basements, and any over-length run; re-routing moves a vent from the roof to a side wall (or vice versa). Both are quoted on a walkthrough — we'll tell you whether a booster fan or a re-route is the better long-term fix.

Yes — bird nests, mice, and squirrels are the main three. Standard protocol: confirm the animal has exited (or arrange removal), brush and vacuum the contaminated line, sanitize the duct, and install a properly screened vent hood cap so re-entry is blocked.